SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR BODY PANELSBODY REAR ENDREPAIR INSTRUCTIONSLIFTGATE CONTROL MODULE PROGRAMMING
2004 Oldsmobile Bravada AWD

Liftgate Control Module Programming

2004 Oldsmobile Bravada AWDSECTION Liftgate Control Module Programming
  1. The liftgate module (LGM) must be programmed with the proper RPO configurations. The LGM stores the information regarding the vehicle options. If the LGM is not properly configured with the correct RPO codes the LGM will not control the features properly. Ensure that the following conditions exist in order to prepare for the LGM programming:
    • The battery is fully charged.
    • The ignition switch is in the RUN position.
    • The data link connector (DLC) is accessible.
  2. Follow the instructions on the Techline Terminal and scan tool to program the LGM.
  3. If the LGM fails to accept the program, perform the following steps:
    • Inspect all LGM connections.
    • Verify that the Techline Terminal and scan tool have the latest software version.

If the liftgate module has been replaced, you must also reprogram the key Fobs.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.