Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1998EIGHTY-EIGHT V6-3.8L VIN KREPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSAIR BAG CONTROL MODULESERVICE AND REPAIRINSTALLATION PROCEDURE
1998 Oldsmobile Eighty-Eight V6-3.8L VIN K
Installation Procedure
1998 Oldsmobile Eighty-Eight V6-3.8L VIN KSECTION Installation Procedure
Installation Procedure
1. Install the SDM (3) to the floor sheetmetal (2).
2. Install the SDM mounting fasteners (1).
NOTICE: Refer to Fastener Notice.
Tighten
Tighten fasteners to 9 N.m (80 lb. in).
3. Install the SDM harness connector (2) to the SDM (1).
Description:
Description:
4. Install the Connector Position Assurance (CPA) (3) to the SDM harness (2) connector.
5. Install the sill plate (RH).
6. Install the passenger front seat.
7. Enable the SIR system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.