Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1998EIGHTY-EIGHT V6-3.8L VIN KREPAIR AND DIAGNOSISLIGHTING AND HORNSINTERIOR LIGHTING MODULESERVICE AND REPAIR
1998 Oldsmobile Eighty-Eight V6-3.8L VIN K
Interior Lighting Module: Service and Repair
1998 Oldsmobile Eighty-Eight V6-3.8L VIN KSECTION Service and Repair
REMOVAL PROCEDURE
1. Partially remove the knee bolster.
2. Disconnect the electrical connector from the interior lighting control module.
3. Complete the removal of the knee bolster.
4. Remove the interior lighting control module from the knee bolster.
INSTALLATION PROCEDURE
1. Install the interior lighting control module to the knee bolster.
2. Partially install the knee bolster.
3. Connect the electrical connector to the module.
4. Install the knee bolster.
1. Partially remove the knee bolster.
2. Disconnect the electrical connector from the interior lighting control module.
3. Complete the removal of the knee bolster.
4. Remove the interior lighting control module from the knee bolster.
INSTALLATION PROCEDURE
1. Install the interior lighting control module to the knee bolster.
2. Partially install the knee bolster.
3. Connect the electrical connector to the module.
4. Install the knee bolster.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.