Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1997LSS V6-3.8L VIN KREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGREFRIGERANT PRESSURE SENSOR / SWITCHSERVICE AND REPAIR
1997 Oldsmobile LSS V6-3.8L VIN K
Refrigerant Pressure Sensor / Switch: Service and Repair
1997 Oldsmobile LSS V6-3.8L VIN KSECTION Service and Repair
Remove or Disconnect
1. Electrical connection from switch
2. Switch and O-ring seal.
Install or Connect
1. Switch and new O-ring seal.
^ Lube O-rings with clean 525 or Mineral oil.
Tighten
^ Switch to 5 N.m (44 lb. in.).
2. Electrical connection to switch
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.