SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1997LSS V6-3.8L VIN KREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSSERVICE AND REPAIRPERSONAL AUTOMOTIVE SECURITY SYSTEM PASS-KEY IIPASS-KEY II MODULE REPLACEMENTREMOVE AND REPLACE
1997 Oldsmobile LSS V6-3.8L VIN K

Remove and Replace

1997 Oldsmobile LSS V6-3.8L VIN KSECTION Remove and Replace

PASS Key II Module:




REMOVE OR DISCONNECT
1. I/P storage compartment.
2. Fastener from rear edge of module.
3. PASS Key II module from bracket.
4. Electrical connection(s).

INSTALL OR CONNECT
1. Electrical connection(s).
2. PASS Key II module to bracket.
3. Fastener.
4. I/P storage compartment.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.