Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1996EIGHTY-EIGHT LSS FWD V6-3.8L VIN KREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVOSERVICE AND REPAIR
1996 Oldsmobile Eighty-Eight LSS FWD V6-3.8L VIN K
Cruise Control Servo: Service and Repair
1996 Oldsmobile Eighty-Eight LSS FWD V6-3.8L VIN KSECTION Service and Repair
1. Remove throttle body intake ductwork, then disconnect retainer at servo blade.
2. Disconnect cruise control cable at from servo bracket by release locking tangs.
3. Disconnect vacuum hoses and electrical connector.
4. Remove servo bracket nuts, servo and bracket assembly.
5. Remove bolts retaining servo to bracket, then servo.
6. Reverse procedure to install noting the following:
a. Torque servo to bracket bolts to 14 ft. lbs.
b. Torque servo bracket nuts to 0.0 ft. lbs.
c. Retainer must be installed with tang secured over cable stud head.
2. Disconnect cruise control cable at from servo bracket by release locking tangs.
3. Disconnect vacuum hoses and electrical connector.
4. Remove servo bracket nuts, servo and bracket assembly.
5. Remove bolts retaining servo to bracket, then servo.
6. Reverse procedure to install noting the following:
a. Torque servo to bracket bolts to 14 ft. lbs.
b. Torque servo bracket nuts to 0.0 ft. lbs.
c. Retainer must be installed with tang secured over cable stud head.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.