Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
CONSULT Function
APPLICATION ITEM
CONSULT performs the following functions.
| Diagnosis mode | CGW Status | Description | ||
|---|---|---|---|---|
| Restricted Mode | Diag Test Mode | Open Mode | ||
| CGW Information | Display | Display | Display |
|
| Data Monitor | Display | Display | Display | Displays the real-time input signal of occupant detection system control unit. |
| Work support | Non-display | Non-display | Display | This mode enables a technician to adjust some devices faster and more accurately by following the indications on the CONSULT. |
CGW INFORMATION
Display the diagnosis mode which a user can perform in Diag Test mode/Open Mode by switching the CGW status from Restricted mode to Diag Test Mode/Open Mode. For the method of switching CAN Gateway status. Refer to CONSULT Function .
DATA MONITOR
| Monitor Item | Contents |
|---|---|
| Buckle Switch Status [Not Moni/Unfasten/Fasten/Reload] | The switch status input from front seat belt buckle switch RH.
|
| Buckle Switch Spec [Not Moni/Nor Op/Nor Cl/Frm ACU] | Displays the spec of the front seat belt buckle switch RH.
|
| Buckle Switch Status (Comm) [Not Moni/Moni (wir)/Frm ACU] | Displays the status of the front seat belt buckle switch RH signal.
|
WORK SUPPORT
| Test item | Description |
| Zero point reset function | Perform zero point reset. Refer to Description . |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.