SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2025ROGUE ROCK CREEKREPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMSSRS AIR BAG CONTROL SYSTEMBASIC INSPECTIONZERO POINT RESETWORK PROCEDURE
2025 Nissan-Datsun Rogue Rock Creek

Work Procedure

2025 Nissan-Datsun Rogue Rock CreekSECTION Work Procedure
  1. PERFORM ZERO POINT RESET 
    1. Perform zero point reset.
      NOTE: SYMBOL When performing zero point reset, be careful of the items described as per the following.
      • Perform zero point reset after installing passenger seat to the vehicle
      • Never put any objects on passenger seat
      • Never apply excessive vibration to the vehicle
      • Never touch the vehicle
      • Never tilt the vehicle
    2. Select start on "Zero point reset function" screen from, WORK SUPPORT of CONSULT "OCCUPANT DETECTION".
    3. "Zero point reset" starts.

    >>

    GO TO 2.

  2. CONFIRMATION OF SETTING 
    1. Proceed to "Zero point reset function" screen from work support of CONSULT "OCCUPANT DETECTION".
    2. Check that "Already performed" or "Not yet performed" is displayed on "Zero point reset current status".
    CAUTION:
    • "Already performed" is displayed on "Zero point reset current status" if the seat is reinstalled by seat removal and installation, or zero point reset is already performed.
    • "Zero point reset current status" displays "Not yet performed" if a new seat is installed. When ignition switch ON without performing zero point reset, SRS air bag warning lamp keeps turning ON. When zero point reset is performed, SRS air bag warning lamp turns OFF.
    • Air bag diagnosis sensor unit does not record whether or not zero point reset is performed.

    Is condition "Already performed"?

    YES>>

    WORK END

    NO>>

    Check condition as per the following, and perform zero point reset again.

    • Passenger seat is occupied by an object.
    • Excessive vibration is applied while performing zero point reset.
    • Occupant detection system is malfunctioning.
      NOTE: SYMBOL If "Not yet performed" is displayed on "Zero point reset current status", zero point reset is not completed normally. Check the condition as per the following and perform zero point reset again.
    • Passenger seat is occupied by an object.
    • Excessive vibration is applied while performing zero point reset.
    • Occupant detection system is malfunctioning.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.