Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2025ROGUE ROCK CREEKREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (DTC/CIRCUIT DIAGNOSIS) (5 OF 5)DTC/CIRCUIT DIAGNOSISFUEL PUMP CONTROL MODULECOMPONENT INSPECTION
2025 Nissan-Datsun Rogue Rock Creek
Component Inspection
2025 Nissan-Datsun Rogue Rock CreekSECTION Component Inspection
- CHECK FUEL PUMP CONTROL MODULE (FPCM)
- Check the voltage between FPCM terminals under the following conditions.
FPCM Condition Voltage (Approx.) Connector + - Terminal B97 6 5 For 1 second after turning ignition switch ON 9.9 V More than 1 second after turning ignition switch ON 0 V Idle speed 9.9 V
Is the inspection result normal?
YES>>
INSPECTION END
NO>>
Replace FPCM. Refer to Removal and Installation .
- Check the voltage between FPCM terminals under the following conditions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.