Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2025ROGUE ROCK CREEKREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (DTC/CIRCUIT DIAGNOSIS) (3 OF 5)DTC/CIRCUIT DIAGNOSISDTC P11A0: VCR CONTROL MODULEDTC DIAGNOSIS PROCEDURE
2025 Nissan-Datsun Rogue Rock Creek
DTC Diagnosis Procedure
2025 Nissan-Datsun Rogue Rock CreekSECTION DTC Diagnosis Procedure
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON.
- Erase DTC.
- Perform DTC confirmation procedure. DTC Description
Is the DTC P11A0 displayed again?
YES>>
Replace VCR control module. Refer to VCR CONTROL MODULE : Removal and Installation .
NO>>
INSPECTION END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.