SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2025ROGUE ROCK CREEKREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (DTC/CIRCUIT DIAGNOSIS) (3 OF 5)DTC/CIRCUIT DIAGNOSISDTC P10CA: INTERNAL CONTROL MODULE FUEL INJECTORDTC DESCRIPTION
2025 Nissan-Datsun Rogue Rock Creek

DTC Description

2025 Nissan-Datsun Rogue Rock CreekSECTION DTC Description

DTC DETECTION LOGIC 

DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition
P10CA 00 Cylinder 3 injector A (Cylinder 3 injector A) Diagnosis condition -
Signal (terminal) -
Threshold
  • Injector driver unit is malfunctioning.
  • ECM detects No. 3 injector circuit is shorted.
Diagnosis delay time -

POSSIBLE CAUSE 

  • Harness or connectors
    • Fuel injector circuit is open
  • Battery power supply
  • ECM (Direct injector driver unit)
  • Fuel injector

FAIL-SAFE 

Engine Control System 

Fail safe mode Vehicle behavior
Traveling control mode Accelerator angle variation control ECM controls the accelerator pedal depression speed to make it slower than actual speed. This causes a drop in accelerating performance and encourages the driver to repair malfunction.
NOTE: SYMBOL ECM does not control the accelerator pedal releasing speed.
Device fix mode
  • This mode fixes the electric IVT control actuator and the EVT control solenoid valve in the reference position.
  • A control signals is not transmitted to the EGR volume control valve and the EGR volume control is deactivated.
Combustion control mode Stratified charge combustion control at starting No stratified charge combustion at starting (cold start).

Stop/Start System 

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.

DTC Confirmation Procedure 

  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    • Before performing the following procedure, confirm that battery voltage is between 12 - 15 V at idle.

    >>

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and let it idle for at least 20 seconds.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES>>

    Refer to DTC Diagnosis Procedure .

    NO-1>>

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO-2>>

    Confirmation after repair: INSPECTION END

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.