Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2025ROGUE ROCK CREEKREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM (2 OF 2)REMOVAL AND INSTALLATIONELECTRIC INTAKE VALVE TIMING CONTROL MODULEELECTRIC INTAKE VALVE TIMING CONTROL MODULE : REMOVAL AND INSTALLATION
2025 Nissan-Datsun Rogue Rock Creek
ELECTRIC INTAKE VALVE TIMING CONTROL MODULE : Removal and Installation
2025 Nissan-Datsun Rogue Rock CreekSECTION ELECTRIC INTAKE VALVE TIMING CONTROL MODULE : Removal and Installation
CAUTION:
Perform "ELECTRIC INTAKE VALVE TIMING CONTROL LEARNING". Refer to Work Procedure .
REMOVAL
- Disconnect negative battery terminals, then wait at least three minutes. Refer to Removal and Installation .
- Partially remove the fender protector (LH). Refer to Exploded View .
- Remove the relay box.
- Disconnect the harness connector from the electric intake valve timing control module and VCR control module.
- Remove the electric intake valve timing control module and VCR control module bracket.
- Remove the electric intake valve timing control module nuts.
- Remove the electric intake valve timing control module.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Perform "ELECTRIC INTAKE VALVE TIMING CONTROL LEARNING". Refer to Work Procedure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.