ECM : Removal and Installation

2025 Nissan-Datsun Rogue Rock CreekSECTION ECM : Removal and Installation
CAUTION:
  • Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to Work Procedure .
  • When replacing the ECM, a new ECM must be used. The functions controlled by the ECM do not operate properly if an ECM from another vehicle is used.
  • Perform "ELECTRIC INTAKE VALVE TIMING CONTROL LEARNING". Refer to Work Procedure .

REMOVAL 

  1. Remove the battery. Refer to Removal and Installation .
  2. Disconnect the harness connectors from the ECM. Refer to Harness Connector (lever locking type).
  3. Remove the battery tray. Refer to BATTERY TRAY ; Removal and Installation .
  4. Remove the ECM and bracket assembly.
  5. Remove the nuts and ECM from the bracket.

INSTALLATION 

Installation is in the reverse order of removal.

CAUTION:

Perform "ADDITIONAL SERVICE WHEN REPLACING ECM". Refer to Work Procedure .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.