Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine warning
DESIGN/PURPOSE
Warn the driver that the state of the engine.
| Symbol | Message |
|---|---|
|
BULB CHECK
Not applicable
OPERATION AT COMBINATION METER CAN COMMUNICATION CUT-OFF OR UNUSUAL SIGNAL
For the operation for CAN communications blackout or abnormal signal reception, Fail-Safe (FULL TFT METER) or Fail-Safe (7 INCH INFORMATION DISPLAY).
SYSTEM DIAGRAM
SIGNAL PATH
ECM transmits the engine warning display signal to combination meter via CAN communication. Then the engine warning displays.
LIGHTING CONDITION
When all of the following conditions is satisfied:
- Ignition switch: ON
- Failure of powertrain which may cause serious accident is detected.
- Driving condition may cause accident or situation that car cannot run.
SHUTOFF CONDITION
When any of the following conditions is satisfied:
- Ignition switch: OFF
- Failure of powertrain which may cause serious accident is not detected.
- No problem about driving condition.
TIMING CHART
| t | : 100 ms |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.