Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2025ROGUE ROCK CREEKREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM (1 OF 2)SYSTEM DESCRIPTIONDIAGNOSIS SYSTEM (VCR CONTROL MODULE)CONSULT FUNCTION
2025 Nissan-Datsun Rogue Rock Creek
CONSULT Function
2025 Nissan-Datsun Rogue Rock CreekSECTION CONSULT Function
SELF DIAGNOSTIC RESULT MODE
Freeze Frame Data and 1st Trip Freeze Frame Data
| Freeze frame data item *1 | Description |
|---|---|
| Mileage | The mileage at the moment a malfunction is detected is displayed. |
| DTC count | The DTC count at the moment a malfunction is detected is displayed. |
*1: The items are the same as those of 1st trip freeze frame data.
DATA MONITOR MODE
NOTE:
- The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
- For reference values of the following items, Refer to Values On The Diagnosis Tool .
Monitored Item
| Monitored item | Unit | Description |
|---|---|---|
| ENGINE RPM | RPM | The engine speed sent from ECM is displayed. |
| Ignition switch | Indicates [On/Off] condition from ignition switch signal. | |
| Battery voltage | V | The power supply voltage of ECM is displayed. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.