Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Work Procedure
2025 Nissan-Datsun Rogue Rock CreekSECTION Work Procedure
- PRECONDITIONING
Check that the engine is cold [coolant temperature: 50 °C (122 °F) or less]. Is the engine cold?
YES>>
GO TO 2.
NO>>
Park the vehicle at a cold place and cool down the engine. And then, GO TO 2.
- INITIALIZING A LEARNING VALUE
With CONSULT
- Start the engine and let it idle at least 10 seconds.
- On CONSULT screen, select "ENGINE" >> "Active Test" >> "WASTEGATE ACTUATOR".
- Operate the actuator from the fully closed position to the fully open position and check that actual value is within the range of (- 0.00052) - (+ 0.00052) m when the target value is set at 0 m.
>>
END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.