Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wheel Attachment Hardware
2025 Nissan-Datsun Altima SV, FWDSECTION Wheel Attachment Hardware
NOTE:
For conditions noted below, also check condition of wheel stud holes. Proper lug nut torque is essential. Follow manufacturer's torque specifications and tightening sequence. DO NOT lubricate threads unless specified by the vehicle manufacturer.
| Condition | Code | Procedure |
|---|---|---|
| Bent | A | Require replacement |
| Broken | A | Require replacement |
|
NOTE:
Some manufacturers require replacement of all studs on any wheel if two or more studs or nuts on the same wheel are broken or missing.
|
||
| Loose | A | Require repair or replacement of affected component |
| Lug nut flats rounded | A | Require replacement of nut |
| Lug nut installed backward | B | Require repair |
| Lug nut mating surface dished | A | Require replacement of nut |
| Lug nut mating type incorrect | B | Require replacement of nut |
| Lug nut seized | A | Require replacement of nut and/or stud |
| Stud incorrect | B | Require replacement of stud |
| Threads damaged | A | Require repair or replacement of component with damaged threads |
| Threads stripped (threads missing) | A | Require replacement of component with stripped threads |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.