Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2009LANCER L4-2.4L (4B12)REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINCONTINUOUSLY VARIABLE TRANSMISSION/TRANSAXLETESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESHOW TO PERFORM ACTUATOR TEST CVT
2009 Mitsubishi Lancer L4-2.4L (4B12)
How to Perform Actuator Test CVT
2009 Mitsubishi Lancer L4-2.4L (4B12)SECTION How to Perform Actuator Test CVT
HOW TO PERFORM ACTUATOR TEST
Required Special Tools:
^ MB991958: Scan Tool (M.U.T-III Sub Assembly)
^ MB991824: V.C.I.
^ MB991827: M.U.T.-III USB Cable
^ MB991910: M.U.T.-III Main Harness A
CAUTION:
To prevent damage to scan tool MB991958. always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. Select "System select" from the start-up screen.
4. Select "From 06 MY"
5. Make sure vehicle information is correct.
6. Select "AT/CVT/A-MT/TC-SST"
7. Select "Actuator Test."
8. Choose an appropriate item and select the "OK" button.
Required Special Tools:
^ MB991958: Scan Tool (M.U.T-III Sub Assembly)
^ MB991824: V.C.I.
^ MB991827: M.U.T.-III USB Cable
^ MB991910: M.U.T.-III Main Harness A
CAUTION:
To prevent damage to scan tool MB991958. always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. Select "System select" from the start-up screen.
4. Select "From 06 MY"
5. Make sure vehicle information is correct.
6. Select "AT/CVT/A-MT/TC-SST"
7. Select "Actuator Test."
8. Choose an appropriate item and select the "OK" button.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.