Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2009LANCER L4-2.4L (4B12)REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINCONTINUOUSLY VARIABLE TRANSMISSION/TRANSAXLETESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSKEY INTERLOCK MECHANISM CHECK/ADJUSTMENT
2009 Mitsubishi Lancer L4-2.4L (4B12)
Key Interlock Mechanism Check/Adjustment
2009 Mitsubishi Lancer L4-2.4L (4B12)SECTION Key Interlock Mechanism Check/Adjustment
KEY INTERLOCK MECHANISM CHECK/ADJUSTMENT
1. Carry out the following check.
2. If the normal conditions are not obtained after performing the above operations, install the key interlock cable in the following procedures. (Automatic adjustment)
1) Disconnect the key interlock cable connection (selector lever side).
CAUTION:
Leave the ignition switch in the "LOCK" (OFF) position until the key interlock cable installation is completed.
2) Move the selector lever to the ''P" position and turn the ignition switch to the "LOCK" (OFF) position.
3) Install the tip of the key interlock cable to the lock cam of the selector lever assembly, taking care not to twist the inner cable.
4) Install the adjuster case with its lock guide pulled up (unlocked).
5) Securely push down the lock guide to lock it.
NOTE: The lock position of the key interlock cable is automatically adjusted by a spring.
1. Carry out the following check.
2. If the normal conditions are not obtained after performing the above operations, install the key interlock cable in the following procedures. (Automatic adjustment)
1) Disconnect the key interlock cable connection (selector lever side).
CAUTION:
Leave the ignition switch in the "LOCK" (OFF) position until the key interlock cable installation is completed.
2) Move the selector lever to the ''P" position and turn the ignition switch to the "LOCK" (OFF) position.
3) Install the tip of the key interlock cable to the lock cam of the selector lever assembly, taking care not to twist the inner cable.
4) Install the adjuster case with its lock guide pulled up (unlocked).
5) Securely push down the lock guide to lock it.
NOTE: The lock position of the key interlock cable is automatically adjusted by a spring.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.