Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2009LANCER L4-2.4L (4B12)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONDENSER HVACSERVICE AND REPAIR
2009 Mitsubishi Lancer L4-2.4L (4B12)
Condenser HVAC: Service and Repair
2009 Mitsubishi Lancer L4-2.4L (4B12)SECTION Service and Repair
CONDENSER ASSEMBLY
REMOVAL AND INSTALLATION
REMOVAL SERVICE POINTS.
[A]FLEXIBLE SUCTION HOSE AND LIQUID PIPE A DISCONNECTION
CAUTION: As the compressor oil and receiver are highly moisture absorbent, use a non-porous material to plug the hose and nipples.
To prevent the entry of dust or other foreign bodies, plug the dismantled hose and condenser assembly nipples.
[B]CONDENSER ASSEMBLY
DISCONNECTION
1. Lift the condenser while pressing the claw B.
2. Lift the condenser while pressing the claw A and remove it.
REMOVAL AND INSTALLATION
Pre-removal & Post-installation Operation:
Removal Steps 1-6:
REMOVAL SERVICE POINTS.
[A]FLEXIBLE SUCTION HOSE AND LIQUID PIPE A DISCONNECTION
CAUTION: As the compressor oil and receiver are highly moisture absorbent, use a non-porous material to plug the hose and nipples.
To prevent the entry of dust or other foreign bodies, plug the dismantled hose and condenser assembly nipples.
[B]CONDENSER ASSEMBLY
DISCONNECTION
1. Lift the condenser while pressing the claw B.
2. Lift the condenser while pressing the claw A and remove it.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.