Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER L4-2.4L SOHCREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSSERVICE AND REPAIROUTSIDE REAR VIEW MIRROR
2005 Mitsubishi Lancer L4-2.4L SOHC
Outside Rear View Mirror
2005 Mitsubishi Lancer L4-2.4L SOHCSECTION Outside Rear View Mirror
DOOR MIRROR
REMOVAL AND INSTALLATION
Required Special Tool:
- MB990784: Ornament Remover
REMOVAL SERVICE POINT
[[A]] MIRROR REMOVAL
Push the top of the mirror with your hand to tilt it and attach the protective tape as shown in the illustration. Then insert a flat-tipped screwdriver in between the notch at the rear of the mirror and the pivot plate, and disengage the bottom of the mirror.
INSTALLATION SERVICE POINT
]]A[[ MIRROR INSTALLATION
While supporting the clip position on the underside of the pivot plate with a flat-tipped screwdriver, press the clip at the front of the mirror to engage the bottom of the mirror.
REMOVAL AND INSTALLATION
Removal Steps 1-8:
Required Special Tool:
- MB990784: Ornament Remover
REMOVAL SERVICE POINT
[[A]] MIRROR REMOVAL
Push the top of the mirror with your hand to tilt it and attach the protective tape as shown in the illustration. Then insert a flat-tipped screwdriver in between the notch at the rear of the mirror and the pivot plate, and disengage the bottom of the mirror.
INSTALLATION SERVICE POINT
]]A[[ MIRROR INSTALLATION
While supporting the clip position on the underside of the pivot plate with a flat-tipped screwdriver, press the clip at the front of the mirror to engage the bottom of the mirror.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.