Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER L4-2.0L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION CABLETESTING AND INSPECTION
2005 Mitsubishi Lancer L4-2.0L SOHC
Ignition Cable: Testing and Inspection
2005 Mitsubishi Lancer L4-2.0L SOHCSECTION Testing and Inspection
SPARK PLUG CABLE RESISTANCE CHECK
Measure the resistance of the all spark plug leads.
1. Check the cap and coating for cracks.
2. Measure the resistance. Limit: 19 kOhms.
3. If resistance is greater than 19 kOhms, replace the cable.
Measure the resistance of the all spark plug leads.
1. Check the cap and coating for cracks.
2. Measure the resistance. Limit: 19 kOhms.
3. If resistance is greater than 19 kOhms, replace the cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.