Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER L4-2.0L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL LEVEL SENSORTESTING AND INSPECTIONFUEL LEVEL SENSOR FLOAT HEIGHT
2005 Mitsubishi Lancer L4-2.0L SOHC
Fuel Level Sensor Float Height
2005 Mitsubishi Lancer L4-2.0L SOHCSECTION Fuel Level Sensor Float Height
Fuel Level Sensor Float Height
1. Move the float and measure height A at point "F" (highest) and B at point "E" (lowest) with the float arm touching stopper.
Standard value:
- A: 24.1 ± 2 mm (0.95 inch)
- B: 151.6 ± 2 mm (5.97 inches)
2. Adjust the float arm to the standard value, then go to the thermistor check.
1. Move the float and measure height A at point "F" (highest) and B at point "E" (lowest) with the float arm touching stopper.
Standard value:
- A: 24.1 ± 2 mm (0.95 inch)
- B: 151.6 ± 2 mm (5.97 inches)
2. Adjust the float arm to the standard value, then go to the thermistor check.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.