Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER L4-2.0L SOHCREPAIR AND DIAGNOSISMAINTENANCEFLUIDSENGINE OILSERVICE AND REPAIR
2005 Mitsubishi Lancer L4-2.0L SOHC
Engine Oil: Service and Repair
2005 Mitsubishi Lancer L4-2.0L SOHCSECTION Service and Repair
ENGINE OIL (CHANGE)
Use the specified oil.
1. After warming up the engine, remove the oil filler cap.
WARNING: Use care, oil could be hot.
2. Remove the drain plug to allow the engine oil to drain.
3. Replace the drain plug gasket with a new one, and then tighten the drain plug to the specified torque.
Tightening torque: 39 ± 5 Nm (29 ± 4 ft. lbs.)
NOTE: Install the drain plug gasket so it faces in the direction shown in the illustration.
4. Pour new engine oil in through the oil filler tube.
Engine oil capacity:
<2.0L Engine> 3.8 dm3 (4.0 quarts)
<2.4L Engine> 4.3 dm3 (4.5 quarts)
5. Start the engine and run it at idle for a few minutes.
6. Stop the engine and check to ensure that the engine oil level is within the level range indicated on the dip stick.
Use the specified oil.
1. After warming up the engine, remove the oil filler cap.
WARNING: Use care, oil could be hot.
2. Remove the drain plug to allow the engine oil to drain.
3. Replace the drain plug gasket with a new one, and then tighten the drain plug to the specified torque.
Tightening torque: 39 ± 5 Nm (29 ± 4 ft. lbs.)
NOTE: Install the drain plug gasket so it faces in the direction shown in the illustration.
4. Pour new engine oil in through the oil filler tube.
Engine oil capacity:
<2.0L Engine> 3.8 dm3 (4.0 quarts)
<2.4L Engine> 4.3 dm3 (4.5 quarts)
5. Start the engine and run it at idle for a few minutes.
6. Stop the engine and check to ensure that the engine oil level is within the level range indicated on the dip stick.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.