Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER L4-2.0L SOHCREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMSERVICE AND REPAIRFRONTDISASSEMBLY AND ASSEMBLY
2005 Mitsubishi Lancer L4-2.0L SOHC
Disassembly and Assembly
2005 Mitsubishi Lancer L4-2.0L SOHCSECTION Disassembly and Assembly
DISASSEMBLY AND ASSEMBLY
LUBRICATION POINTS
DISASSEMBLY SERVICE POINTS
When disassembling the disc brakes, disassemble both sides (left and right) as a set.
<> PISTON BOOT/PISTON REMOVAL
CAUTION: Blow air little by little to remove the piston. The piston will rush out if a force of air is applied suddenly.
Place a piece of wood, etc. against the caliper body as shown.
Blow compressed air through the brake hose to remove the piston boot and piston.
<> PISTON SEAL REMOVAL
CAUTION: Do not use a flat-tipped screwdriver or similar tool to remove piston seal. These may damage the inner side of the cylinder.
1. Remove the piston seal with your finger tip.
2. Clean the piston surface and inner cylinder with alcohol or brake fluid DOT 3 or DOT 4.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.