Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER EVOLUTION L4-2.0L DOHC TURBOREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSSERVICE AND REPAIRWINDSHIELD WIPER
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo
Windshield Wiper
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC TurboSECTION Windshield Wiper
WINDSHIELD WIPER
REMOVAL AND INSTALLATION
NOTE: For removal and installation of the wiper and washer switch, refer to Chassis Electrical, Column switch.
REMOVAL SERVICE POINT
[[A]] WINDSHIELD WIPER MOTOR ASSEMBLY REMOVAL
1. Remove the windshield wiper motor assembly mounting bolt.
CAUTION: Be careful not to damage the windshield glass when the windshield wiper motor assembly is removed.
2. Use the flat-tipped screwdriver to disengage the link between the windshield wiper motor assembly and the link assembly to remove the windshield wiper motor assembly.
INSTALLATION SERVICE POINTS
]]A[[ WIPER BLADE INSTALLATION
CAUTION: Ensure that the backings are bent in the shown direction, and then install the backings to the wiper blade.
]]B[[ WIPER BLADE ASSEMBLY INSTALLATION
Install the wiper blades at the specified position (standard value).
Standard value (A) : 34 ± 5 mm (1.3 ± 0.20 inch)
REMOVAL AND INSTALLATION
Removal Steps 1-9:
NOTE: For removal and installation of the wiper and washer switch, refer to Chassis Electrical, Column switch.
REMOVAL SERVICE POINT
[[A]] WINDSHIELD WIPER MOTOR ASSEMBLY REMOVAL
1. Remove the windshield wiper motor assembly mounting bolt.
CAUTION: Be careful not to damage the windshield glass when the windshield wiper motor assembly is removed.
2. Use the flat-tipped screwdriver to disengage the link between the windshield wiper motor assembly and the link assembly to remove the windshield wiper motor assembly.
INSTALLATION SERVICE POINTS
]]A[[ WIPER BLADE INSTALLATION
CAUTION: Ensure that the backings are bent in the shown direction, and then install the backings to the wiper blade.
]]B[[ WIPER BLADE ASSEMBLY INSTALLATION
Install the wiper blades at the specified position (standard value).
Standard value (A) : 34 ± 5 mm (1.3 ± 0.20 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.