Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER EVOLUTION L4-2.0L DOHC TURBOREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSSUSPENSIONCONTROL ARM
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo
Control Arm
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC TurboSECTION Control Arm
Front
Lower arm to crossmember connection bolt (Rear) 167 ± 9 Nm (123 ± 7 ft. lbs.)
Lower arm to crossmember connection bolt (Front) 186 ± 10 Nm (138 ± 7 ft. lbs.)
Lower arm to knuckle connection nut 108 ± 10 Nm (80 ± 7 ft. lbs.)
Rear
Upper arm assembly Upper arm assembly mounting bolt (front) 49 ± 5 Nm (36 ± 4 ft. lbs.)
Upper arm assembly mounting bolt (rear) 64 ± 4 Nm (47 ± 3 ft. lbs.)
Upper arm assembly to knuckle nut 81 ± 6 Nm (60 ± 4 ft. lbs.)
Lower arm to crossmember connection bolt (Rear) 167 ± 9 Nm (123 ± 7 ft. lbs.)
Lower arm to crossmember connection bolt (Front) 186 ± 10 Nm (138 ± 7 ft. lbs.)
Lower arm to knuckle connection nut 108 ± 10 Nm (80 ± 7 ft. lbs.)
Rear
Upper arm assembly Upper arm assembly mounting bolt (front) 49 ± 5 Nm (36 ± 4 ft. lbs.)
Upper arm assembly mounting bolt (rear) 64 ± 4 Nm (47 ± 3 ft. lbs.)
Upper arm assembly to knuckle nut 81 ± 6 Nm (60 ± 4 ft. lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.