Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER EVOLUTION L4-2.0L DOHC TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSENGINE CONTROLS - REVISED MISFIRE DTC INFORMATION
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo
Engine Controls - Revised Misfire DTC Information
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC TurboSECTION Engine Controls - Revised Misfire DTC Information
No: TSB-10-13-007
DATE: July, 2010
MODEL: See below
SUBJECT:
MISFIRE DTCS SET DUE TO LOW FUEL LEVEL -
SERVICE MANUAL REVISION
[TSB Revision TSB-10-13-007]
PURPOSE
The misfire DTCs listed below can be set due to fuel aeration caused by low fuel level. This possible cause has been added to the diagnosis procedures for these DTCs.
AFFECTED VEHICLES
All 1995 & later Mitsubishi powertrain models with On-Board Diagnostics capable of setting the above misfire DTCs
DETAILS
Add the information shown to DTCs P0300 through P0306 diagnosis procedures.
DATE: July, 2010
MODEL: See below
SUBJECT:
MISFIRE DTCS SET DUE TO LOW FUEL LEVEL -
SERVICE MANUAL REVISION
[TSB Revision TSB-10-13-007]
PURPOSE
The misfire DTCs listed below can be set due to fuel aeration caused by low fuel level. This possible cause has been added to the diagnosis procedures for these DTCs.
AFFECTED VEHICLES
All 1995 & later Mitsubishi powertrain models with On-Board Diagnostics capable of setting the above misfire DTCs
DETAILS
Add the information shown to DTCs P0300 through P0306 diagnosis procedures.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.