Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER EVOLUTION L4-2.0L DOHC TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSINFORMATION BUSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSSERVICE DATA CHECK
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo
Service Data Check
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC TurboSECTION Service Data Check
SERVICE DATA CHECK
Use the scan tool and the SWS monitor kit to check "Data List" or "Function Diag."
1. This "Data List" or "Function Diag" check is applicable for signals, which are transmitted and received through the SWS communication line. For input signals, which are not compatible with the SWS monitor kit, refer to the Pulse Check procedure (by using the scan tool or voltmeter).
2. The following input signals can be checked by using the scan tool and the SWS monitor kit.
NOTE: If a problem is found in the "Service Data" check, refer to Input Signal Chart.
Use the scan tool and the SWS monitor kit to check "Data List" or "Function Diag."
1. This "Data List" or "Function Diag" check is applicable for signals, which are transmitted and received through the SWS communication line. For input signals, which are not compatible with the SWS monitor kit, refer to the Pulse Check procedure (by using the scan tool or voltmeter).
2. The following input signals can be checked by using the scan tool and the SWS monitor kit.
NOTE: If a problem is found in the "Service Data" check, refer to Input Signal Chart
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.