Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER EVOLUTION L4-2.0L DOHC TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSINFORMATION BUSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSHOW TO CHECK ECUS
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo
How to Check ECUs
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC TurboSECTION How to Check ECUs
HOW TO CHECK ECUS
1. Use the scan tool and the SWS monitor kit to check ECUs. (Refer to MUT-III User's Manual)
2. The following ECUs can be checked by using the scan tool and the SWS monitor kit.
NOTE: The "ECU CO MM Check" function checks communication status of ECUs "NG" does not always mean ECU malfunction. If a malfunction is found by the "ECU COMM Check", proceed to "Symptom Procedure".
SWS monitor kit-compatible ECUs and their conditions
NOTE:
- *1:If the ignition switch is turned to the "LOCK" (OFF) or "ACC" when "NG" is displayed beside the "ETACS ECU" or the signal request line is abnormal, the scan tool shows "NG" beside the "COLUMN ECU".
- *2: When "NG"is displayed beside the "ETACS ECU", the scan tool shows "NG" beside the "FRONT ECU" and "SUNROOF ECU".
1. Use the scan tool and the SWS monitor kit to check ECUs. (Refer to MUT-III User's Manual)
2. The following ECUs can be checked by using the scan tool and the SWS monitor kit.
NOTE: The "ECU CO MM Check" function checks communication status of ECUs "NG" does not always mean ECU malfunction. If a malfunction is found by the "ECU COMM Check", proceed to "Symptom Procedure".
SWS monitor kit-compatible ECUs and their conditions
NOTE:
- *1:If the ignition switch is turned to the "LOCK" (OFF) or "ACC" when "NG" is displayed beside the "ETACS ECU" or the signal request line is abnormal, the scan tool shows "NG" beside the "COLUMN ECU".
- *2: When "NG"is displayed beside the "ETACS ECU", the scan tool shows "NG" beside the "FRONT ECU" and "SUNROOF ECU".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.