Severe Service Defined

2005 Mitsubishi Lancer Evolution L4-2.0L DOHC TurboSECTION Severe Service Defined
SEVERE SERVICE
Vehicles operating under severe service conditions will require more frequent service. Component service information is included in appropriate units for vehicles operating under one or more of the following conditions:
1. Police, taxi, or commercial type operation
2. Operation of Vehicle
(1) Short-trip operation at freezing temperature (engine not thoroughly warmed up)
(2) More than 50% operation in heavy city traffic during hot weather above 32°C (90°F)
(3) Extensive idling
(4) Driving in sandy areas
(5) Driving in salty areas
(6) Driving in dusty conditions
(7) Driving off road

Notes on "Severe Service"

Some vehicle manufacturers provide separate maintenance procedures for vehicles operated under Severe or Special circumstances. Other manufacturers provide recommendations for service at more frequent intervals for vehicles operated under severe conditions. For any vehicle operated under severe conditions, as defined by the vehicles manufacturer, always check the regular maintenance schedule for procedures that may not appear at the similar interval under severe service.

Example:

Manufacturer recommends tire rotation at 10,000 mile intervals under regular maintenance.
There is no tire rotation recommendation shown in the severe service schedule, which has 3,000 mile intervals.

At a minimum, recommend rotation at 9,000 and 18,000 mile intervals etc., or as close to the regular schedule as possible. Depending on vehicle usage and obvious tire wear, this recommendation should be increased as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.