Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMITSUBISHI2005LANCER EVOLUTION L4-2.0L DOHC TURBOREPAIR AND DIAGNOSISMAINTENANCEHOSESPOWER STEERING LINE/HOSESERVICE AND REPAIR

2005 Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo

Power Steering Line/Hose: Service and Repair

2005 Mitsubishi Lancer Evolution L4-2.0L DOHC TurboSECTION Service and Repair

Part 1 Of 2:

Part 2 Of 2:

REMOVAL AND INSTALLATION

REMOVAL SERVICE POINTS
[[A]] EYE BOLT/RETURN TUBE REMOVAL
1. Loosen the crossmember mounting bolts and nuts, and lower the crossmember to a position so that the eye bolts or return tube at the steering gear side can be removed.

NOTE: In this case, do not remove the crossmember mounting bolts and nuts.

2. Remove the eye bolts or return tube.

INSTALLATION SERVICE POINTS
]]A[[ RETURN HOSE INSTALLATION

1. Install the return hose so that the marking is positioned as shown in the illustration.

2. Install the clip as shown in the illustration.

]]B[[ PRESSURE HOSE/SUCTION HOSE INSTALLATION

1. Install the pressure hose on pump side so that the notch is fixed with bracket as shown in the illustration.
2. Install the suction hose so that the marking is positioned as shown in the illustration

3. Install the pressure hose on gear box side so that its plate part is positioned as shown in the illustration.

]]C[[ RETURN HOSE INSTALLATION

Part 1 Of 2:

Install the return hose so that the marking is positioned as shown in the illustration.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.