Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER EVOLUTION L4-2.0L DOHC TURBOREPAIR AND DIAGNOSISMAINTENANCEFLUIDSFLUID - TRANSFER CASESERVICE AND REPAIRTRANSFER OIL REPLACEMENT
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo
Transfer Oil Replacement
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC TurboSECTION Transfer Oil Replacement
TRANSFER OIL REPLACEMENT
1. Remove the filler plug.
2. Remove the drain plug and drain the oil.
3. Tighten the drain plug to the specified torque.
Tightening torque: 32 ± 2 Nm (23 ± 2 ft. lbs.)
4. Fill with MITSUBISHI Limited Slip Differential Oil (LSD) or equivalent until the level comes to the lower portion of filler plug hole.
Quantity: 0.6 dm3 (0.63 quart)
5. Tighten the filler plug to the specified torque.
Tightening torque: 32 ± 2 Nm (23 ± 2 ft. lbs.)
1. Remove the filler plug.
2. Remove the drain plug and drain the oil.
3. Tighten the drain plug to the specified torque.
Tightening torque: 32 ± 2 Nm (23 ± 2 ft. lbs.)
4. Fill with MITSUBISHI Limited Slip Differential Oil (LSD) or equivalent until the level comes to the lower portion of filler plug hole.
Quantity: 0.6 dm3 (0.63 quart)
5. Tighten the filler plug to the specified torque.
Tightening torque: 32 ± 2 Nm (23 ± 2 ft. lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.