Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2005LANCER EVOLUTION L4-2.0L DOHC TURBOREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGAIR CONDITIONING SWITCHTESTING AND INSPECTION
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo
Air Conditioning Switch: Testing and Inspection
2005 Mitsubishi Lancer Evolution L4-2.0L DOHC TurboSECTION Testing and Inspection
HEATER CONTROL ASSEMBLY AND A/C SWITCH
REMOVAL AND INSTALLATION
INSTALLATION SERVICE POINTS
>>A<< MODE SELECTION DAMPER CABLE CONNECTION
1. Set the heater control assembly's mode selection knob to the DEF position.
2. Set the heater unit's mode selection damper lever to the DEF position (turn the damper relay to the left until it stops) and install the cable.
3. Set the mode locator to the heater unit case and secure with a clip.
>>B<< AIR MIX DOOR CABLE CONNECTION
1. Turn the heater control assembly's temperature adjustment knob all the way to the HOT side.
2. Set the heater unit's air mix door lever to the MAX HOT position (turn the damper lever as the left illustration) and attach the cable.
3. Set the mode locator to the heater unit case and secure with a clip.
REMOVAL AND INSTALLATION
Heater Control Assembly And A/C Switch - Removal And Installation Part 1:
Heater Control Assembly And A/C Switch - Removal And Installation Part 2:
INSTALLATION SERVICE POINTS
>>A<< MODE SELECTION DAMPER CABLE CONNECTION
1. Set the heater control assembly's mode selection knob to the DEF position.
2. Set the heater unit's mode selection damper lever to the DEF position (turn the damper relay to the left until it stops) and install the cable.
3. Set the mode locator to the heater unit case and secure with a clip.
>>B<< AIR MIX DOOR CABLE CONNECTION
1. Turn the heater control assembly's temperature adjustment knob all the way to the HOT side.
2. Set the heater unit's air mix door lever to the MAX HOT position (turn the damper lever as the left illustration) and attach the cable.
3. Set the mode locator to the heater unit case and secure with a clip.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.