SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2004LANCER L4-2.4L SOHCREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSPECIFICATIONSMECHANICAL SPECIFICATIONS
2004 Mitsubishi Lancer L4-2.4L SOHC

Mechanical Specifications

2004 Mitsubishi Lancer L4-2.4L SOHCSECTION Mechanical Specifications






General Specifications:







Fastener Tightening Specifications
ITEM SPECIFICATION
A/C pipe mounting bolt (heater/cooler unit side) 4.9 ± 1.0 Nm (44 ± 8 in-lb)
A/C pipe mounting bolt (condenser side) 4.9 ± 1.0 Nm (44 ± 8 in-lb)
A/C pipe mounting nut (suction hose side) 13 ± 2 Nm (109 ± 21 in-lb)
Discharge hose mounting bolt (compressor side) 25 ± 4 Nm (18 ± 4 ft-lb)
Discharge hose mounting nut (condenser side) 4.9 ± 1.0 Nm (44 ± 8 in-lb)
Suction hose mounting bolt (compressor side) 25 ± 4 Nm (18 ± 4 ft-lb)




Service Specifications
ITEM STANDARD VALUE
Idle speed r/min
1.6L engine 700 ± 100*
2.0L engine 700 ± 100*

Idle-up speed r/min 850 ± 100*

Resistor (for blower motor) Ohm
LO 2.54
ML 1.24
MH 0.6

Air gap (magnetic clutch) mm (in) 0.3 - 0.5 (0.012 - 0.020)

NOTE: The rpm marked by an asterisk should be checked 4 minutes after idling begins.


RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.