Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2004LANCER L4-2.4L SOHCREPAIR AND DIAGNOSISBODY AND FRAMEFENDERFRONT FENDERSERVICE AND REPAIR
2004 Mitsubishi Lancer L4-2.4L SOHC
Front Fender: Service and Repair
2004 Mitsubishi Lancer L4-2.4L SOHCSECTION Service and Repair
FENDER
REMOVAL AND INSTALLATION
Required Special Tool:
- MB990784: Ornament Remover
REMOVAL SERVICE POINT
<> SIDE TURN-SIGNAL LIGHT REMOVAL
Use special tool MB990784 to pry out the tab from the fender, and remove the side turn-signal light.
INSTALLATION SERVICE POINT
>>A<< SIDE TURN-SIGNAL LIGHT INSTALLATION
Engage the claw with the fender panel, and install the side turn-signal light.
REMOVAL AND INSTALLATION
Required Special Tool:
- MB990784: Ornament Remover
REMOVAL SERVICE POINT
<> SIDE TURN-SIGNAL LIGHT REMOVAL
Use special tool MB990784 to pry out the tab from the fender, and remove the side turn-signal light.
INSTALLATION SERVICE POINT
>>A<< SIDE TURN-SIGNAL LIGHT INSTALLATION
Engage the claw with the fender panel, and install the side turn-signal light.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.