Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2004GALANT V6-3.8L (6G75)REPAIR AND DIAGNOSISMAINTENANCEALIGNMENTTESTING AND INSPECTION
2004 Mitsubishi Galant V6-3.8L (6G75)
Alignment: Testing and Inspection
2004 Mitsubishi Galant V6-3.8L (6G75)SECTION Testing and Inspection
STEERING ANGLE CHECK
1. Place the front wheel on a turning radius gauge and measure the steering angle.
Standard value
2. If the steering angle is not within the standard value, adjust the toe as follows.
Standard value: 0 ± 3 mm (0 ± 0.12 inch)
1. Loosen the jam nut, and unclip the bellows.
2. Adjust the toe by turning the left and right tie rod turnbuckles by the same amount (in opposite directions).
NOTE: The toe will move out as the left turnbuckle is turned toward the front of the vehicle and the right turnbuckle is turned toward the rear of the vehicle.
3. Tighten the jam nut to the specified torque, and tighten the bellows by the clip.
Tightening torque: 52 ± 2 Nm (38 ± 2 ft. lbs.)
3. Recheck the steering angle.
1. Place the front wheel on a turning radius gauge and measure the steering angle.
Standard value
2. If the steering angle is not within the standard value, adjust the toe as follows.
Standard value: 0 ± 3 mm (0 ± 0.12 inch)
1. Loosen the jam nut, and unclip the bellows.
2. Adjust the toe by turning the left and right tie rod turnbuckles by the same amount (in opposite directions).
NOTE: The toe will move out as the left turnbuckle is turned toward the front of the vehicle and the right turnbuckle is turned toward the rear of the vehicle.
3. Tighten the jam nut to the specified torque, and tighten the bellows by the clip.
Tightening torque: 52 ± 2 Nm (38 ± 2 ft. lbs.)
3. Recheck the steering angle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.