Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI1990ECLIPSE AWD L4-1997CC 2.0L DOHC TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMSPARK PLUGSERVICE AND REPAIR
1990 Mitsubishi Eclipse AWD L4-1997cc 2.0L DOHC Turbo
Spark Plug: Service and Repair
1990 Mitsubishi Eclipse AWD L4-1997cc 2.0L DOHC TurboSECTION Service and Repair
1. Remove center cover.
2. Remove spark plug wires from spark plugs.
3. Using the proper sized spark plug socket, remove the spark plugs by turning them counterclockwise.
4. Gap the new spark plugs to specifications.
SPARK PLUG GAP:
Standard Value .039 - .043 in (1.0 - 1.1 mm)
5. Lightly coat threads with an approved anti-seize compound prior to installation.
6. Install spark plugs by turning them clockwise. Torque spark plugs to specifications.
TORQUE VALUE:
Spark plugs 15 - 21 ftlb (20 - 30 Nm)
2. Remove spark plug wires from spark plugs.
3. Using the proper sized spark plug socket, remove the spark plugs by turning them counterclockwise.
4. Gap the new spark plugs to specifications.
SPARK PLUG GAP:
Standard Value .039 - .043 in (1.0 - 1.1 mm)
5. Lightly coat threads with an approved anti-seize compound prior to installation.
6. Install spark plugs by turning them clockwise. Torque spark plugs to specifications.
TORQUE VALUE:
Spark plugs 15 - 21 ftlb (20 - 30 Nm)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.