Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI1990ECLIPSE AWD L4-1997CC 2.0L DOHC TURBOREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRPRELIMINARY CHECK
1990 Mitsubishi Eclipse AWD L4-1997cc 2.0L DOHC Turbo
Preliminary Check
1990 Mitsubishi Eclipse AWD L4-1997cc 2.0L DOHC TurboSECTION Preliminary Check
1. Ensure tires are inflated to correct pressure, then check for uneven wear.
2. Check front wheel bearings, suspension arm, and ball joints for damage and replace components as necessary, to eliminate improper alignment due to faulty components.
3. Check steering gear for damage and adjust as necessary.
4. Check shocks for damage and replace as necessary.
5. Rock vehicle backward and forward and bounce it upward and downward to settle vehicle prior to alignment.
6. Ensure vehicle is unloaded and on a suitable alignment rack according manufacturers' instructions. When measuring equipment is attached directly to outer end of driveshaft and front wheels are on turntables, apply brake to prevent improper vehicle movement.
2. Check front wheel bearings, suspension arm, and ball joints for damage and replace components as necessary, to eliminate improper alignment due to faulty components.
3. Check steering gear for damage and adjust as necessary.
4. Check shocks for damage and replace as necessary.
5. Rock vehicle backward and forward and bounce it upward and downward to settle vehicle prior to alignment.
6. Ensure vehicle is unloaded and on a suitable alignment rack according manufacturers' instructions. When measuring equipment is attached directly to outer end of driveshaft and front wheels are on turntables, apply brake to prevent improper vehicle movement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.