Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 987 (GENERAL ELECTRICAL SYSTEM - REPAIR INSTRUCTIONS)WINDOW WASHER SYSTEM61 71... CHECKING FUNCTION OF SPRAY NOZZLES FOR WINDSHIELD WASHER SYSTEM
2013 Mini Cooper Countryman, Standard Trans
61 71... Checking function of spray nozzles for windshield washer system
2013 Mini Cooper Countryman, Standard TransSECTION 61 71... Checking function of spray nozzles for windshield washer system
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 BMW 745i, 2005 BMW 745Li, 2004 BMW 745i, 2004 BMW 745Li, and 2003 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.
- Switch on terminal "R" and then switch on again immediately.
- Press wiper lever to "Clean windshield" for more than 3 seconds.
- Washer fluid is sprayed out of the spray nozzles without the wiper arms being moved.
- Check function of spray nozzles.
- Spray nozzles cannot be adjusted.
- If necessary, replace spray nozzles. Refer to 61 71 016 REMOVING AND INSTALLING/REPLACING A JET NOZZLE IN WINDSHIELD WASHER SYSTEM .
- Top up washer fluid.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.