Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 958 (Engine Electrical System - Repair Instructions): Troubleshooting: Notes
Always switch off ignition before working on ignition system. Use only test leads which have been approved and belong to the testing instruments (e.g. DIS Tester). Comply with operating instructions of the respective testing instrument used. Comply with the country-specific safety regulations. Never touch components conducting current with engine running! Comply with instructions of DIS tester. Do not connect any suppression capacitors or inspection lamps to terminal 1 on the ignition coil. Terminal 1 of ignition coil must not be connected to ground or battery positive lead. If an alarm system is subsequently installed, lead of terminal 1 must not be used for start prevention. When working on ignition system, always disconnect supply leads to ignition coils. Ignition coil (high voltage at terminal 4 is approx. 40 kV) - Lead of terminal 1 from ignition coil to DME control unit (high voltage approx. 350 V).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.