Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 00... Battery
- Battery Master Document
- Disconnecting battery, refer to 12 00... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
- Battery charging, refer to 61 00... BATTERY CHARGING .
- Welding work, refer to WELDING WORK (OVERLOAD PROTECTION OF CONTROL UNITS .
- External jump-starting aid, refer to EXTERNAL JUMP-STARTING AID .
Battery Care And Maintenance
In low-maintenance batteries, check the acid level at least once a year. If necessary, top up with distilled water up to the top marking.
The increasing number of electronic control units in the car reduces the self-discharging time of the battery (even in standby mode). To maintain the battery service life and to avoid exhaustive discharging, recharge laid-up vehicles every 6 weeks at the latest . The time for self-discharging depends on vehicle type and equipment specification.
Battery Test
The battery acid density can be used to measure the charge state. However this test produces uncertainty caused by a design-related range of variation. The acid density e.g. for a charged battery is 1.28 kg/l (in the tropical version the acid density is 1.23 kg/l).
Another interference factor is the acid lamination immediately after filling with distilled water.
Battery wear with partially sulfated and/or heavily contaminated plates will also lead to incorrect acid density test results.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.