Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 85 (STEERING COLUMN - REPAIR)REMOVAL & INSTALLATIONSTEERING COLUMNINSTALLATION
2013 Mini Cooper Countryman, Standard Trans
Steering Column: Installation
2013 Mini Cooper Countryman, Standard TransSECTION Installation
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 2003 BMW 530i, 2003 BMW 525i, 2002 BMW M5, 2002 BMW 540i, and 2002 BMW 530i. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Ensure installation of screw (1), spacer tube (2), guide bush (3) and shim (4). See Fig 1.
- Install bracket (1), spacer (2), bolt (3), plastic guide, inside face slightly greased (4), washer (5), and replace self-locking nut (6). See Figure. Tighten nut to specification. See TORQUE SPECIFICATIONS .
- Fit spacer tube and tighten shear-off bolts until heads shear off.
- Ensure clamping screw locates in retaining groove in steering spindle. See Figure. Replace self-locking nut and tighten to specification. See TORQUE SPECIFICATIONS .
- Check position of collar (1) relative to snap ring (2). See Figure.
- Carry out steering angle offset for Electronic Damper Control/Dynamic Stability Control. See BMW Diagnosis Program.
- Check for freedom of movement over entire adjustment range of steering column to adjoining components and wires.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.