Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
13 62 531 Replacing coolant temperature sensor (M54)
Turn off ignition.
Installation location:
Coolant temperature sensor (1) is fitted below intake air manifold in cylinder head of cylinder 6.
Remove intake air manifold. Refer to REMOVING AND INSTALLING INTAKE AIR MANIFOLD (M54) .
Disconnect plug connection (1).
Unscrew temperature sensor.
Installation:
Tightening torque 13 62 2AZ
Check coolant level, top up coolant if necessary.
Check stored fault messages.
Rectify faults.
Then clear fault memory.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.