SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 582 (STEERING AND WHEEL ALIGNMENT - TECHNICAL DATA)ELECTRONIC CHASSIS ALIGNMENT32 00 WHEEL ALIGNMENT - NORMAL POSITION/INSPECTION CONDITIONS E65/E66
2013 Mini Cooper Countryman, Standard Trans

32 00 Wheel Alignment - Normal Position/Inspection Conditions E65/E66

2013 Mini Cooper Countryman, Standard TransSECTION 32 00 Wheel Alignment - Normal Position/Inspection Conditions E65/E66
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
WHEEL ALIGNMENT - NORMAL POSITION/INSPECTION CONDITIONS - SPECIFICATIONS (E65/E66)

Car loaded down to normal position   Vehicle with complete equipment for normal operation with: 2 x 68 kg on front seats (seats in central position); 1 x 68 kg on rear seat (center); 1 x 21 kg in luggage compartment (center) and full fuel tank.
Requirements:    
   
  1. Correct rims and tires with uniform tire tread.
  2. Correct tire pressure (refer to instruction plate on vehicle).
  3. Correct wheel bearing clearance.
  4. Ride height check in normal position (see above). Ride level measurement, refer to RIDING HEIGHT .
    WARNING: Repair vehicle in event of deviation from specified value.
  5. On cars with air suspension, extract fuse from air supply unit to ensure vehicle suspension cannot rise or fall. Adjust regulation ride level for measurement = specified value +/- 2mm by loading/unloading vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.