Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
32 00... Troubleshooting After Wheel/Chassis Alignment Check On Rear Axle
Substandard roadholding, atypical noises, tires worn on one side and toe/camber values which deviate from the nominal value are all indicators of damage to the suspension caused by road traffic accidents or similar impacts.
To carry out proper repairs, you must follow the procedure set out in the troubleshooting table below depending on the condition of the vehicle in question.
| Fault | Cause | Remedy |
|---|---|---|
| Camber/toe deviation. | Rubber mount/ball joint of control or guide arm faulty. | Replace control or guide arm. Refer to UPPER CONTROL ARM and SWINGING ARM . |
| Control or guide arm deformed. | Replace control or guide arm. Refer to UPPER CONTROL ARM and SWINGING ARM . | |
| Ball joint in wheel carrier faulty. | Replace ball joint. Refer to WHEEL CARRIER BALL JOINT . | |
| Integral link deformed. | Replace integral link. Refer to INTEGRAL LINK . | |
| Rubber mount of swinging arm faulty. | Replace swinging arm. Refer to SWINGING ARM . | |
| Swinging arm deformed. | Replace swinging arm. Refer to SWINGING ARM . | |
| Rubber mount of rear axle carrier faulty. | Replace rubber mount. Refer to AXLE CARRIER RUBBER MOUNTS . | |
| Rear axle carrier deformed. | Replace rear axle carrier. Refer to AXLE CARRIER . | |
| Rear-wheel position incorrect. | Rear axle carrier laterally displaced/skewed. | Replace rubber mount. Refer to AXLE CARRIER RUBBER MOUNTS . |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.