Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 560 (ENGINE ELECTRICAL SYSTEM - REPAIR INSTRUCTIONS)TROUBLESHOOTING12 00 ... INFORMATION ON WORKING ON IGNITION SYSTEM
2013 Mini Cooper Countryman, Standard Trans
12 00 ... Information On Working On Ignition System
2013 Mini Cooper Countryman, Standard TransSECTION 12 00 ... Information On Working On Ignition System
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2006 BMW 760i, 2006 BMW 760Li, 2005 BMW 760i, 2005 BMW 760Li, and 2004 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
Safety Instructions:
- Always switch off ignition before working on ignition system.
- Use only test leads which have been approved and belong to the testing instruments (e.g. DIS Tester).
- Comply with operating instructions of the respective testing instrument used.
- Comply with the country-specific safety regulations.
- Never touch components conducting current with engine running!
- Comply with instructions of DIS tester.
- Do not connect any suppression capacitors or inspection lamps to terminal 1 on the ignition coil.
- Terminal 1 of ignition coil must not be connected to ground or battery positive lead.
- If an alarm system is subsequently installed, lead of terminal 1 must not be used for start prevention.
- When working on ignition system, always disconnect supply leads to ignition coils.
High Voltage! - Mortal Danger!
CAUTION:
Hazardous voltages occur at:
- Ignition lead.
- Spark-plug connector.
- Spark plug.
- Ignition coil (high voltage at terminal 4 is approx. 40 kV).
- Lead of terminal 1 from ignition coil to DME control unit (high voltage approx. 350 V).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.