Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 459 (STEERING AND WHEEL ALIGNMENT - REPAIR)ELECTRONIC CHASSIS ALIGNMENT32 00... MOVE VEHICLE INTO NORMAL POSITION
2013 Mini Cooper Countryman, Standard Trans
32 00... Move Vehicle Into Normal Position
2013 Mini Cooper Countryman, Standard TransSECTION 32 00... Move Vehicle Into Normal Position
WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Check compliance with test conditions, bring vehicle to a stop if necessary. Refer to STEERING AND WHEEL ALIGNMENT - TECHNICAL DATA .
- Version with air spring system:
- Carry out ride-height-calibration 37 12 010 CARRY OUT RIDE-HEIGHT CALIBRATION
- Pull fuse(s) for air supply unit control unit
- Check vehicle interior and luggage compartment (incl. luggage compartment recess) for load, unload vehicle if necessary
- Introduce DIN load (refer to STEERING AND WHEEL ALIGNMENT - TECHNICAL DATA ) into vehicle
- Determine vehicle ride height, refer to RIDING HEIGHT
Note: If the vehicle ride height is not inside the tolerance (refer to STEERING AND WHEEL ALIGNMENT - TECHNICAL DATA ), the vehicle must be repaired (coil spring/leakage).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.