Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 44 (ELECTRICAL COMPONENT LOCATOR)GROUNDS
2013 Mini Cooper Countryman, Standard Trans
Section 44 (Electrical Component Locator): Grounds
2013 Mini Cooper Countryman, Standard TransSECTION Grounds
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1998 BMW M3, 1998 BMW 328is, 1998 BMW 328i, 1998 BMW 323is, and 1998 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
GROUNDS
| Component | Component Location |
|---|---|
| X165 | Front left side of engine compartment. See Figure . |
| X173 | At left kick panel. See Figure . |
| X494 | Under left front seat. |
| X495 | At right kick panel. |
| X498 | Under left front seat. |
| X1165 | At left kick panel. See Figure . |
| X1166 | At right kick panel. |
| X1441 | Below center console. |
| X6454 | Right rear side of engine compartment. See Figure . |
| X6455 | Left side of engine compartment. |
| X6456 | On cylinder head. |
| X10010 | At right kick panel. |
| X10012 | At right kick panel. |
| X13004 | At right "C" pillar. |
| X13006 | At left "C" pillar. |
| X13009 | At right kick panel. |
| X13016 | Below left side of dash. See Figure . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.