Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 41 (ELECTRICAL COMPONENT LOCATOR)SWITCHES
2013 Mini Cooper Countryman, Standard Trans
Section 41 (Electrical Component Locator): Switches
2013 Mini Cooper Countryman, Standard TransSECTION Switches
WARNING: This page is about a different car, the 1997 BMW 318ti. However, it is still accessible from the selected car via links, so may be relevant.
SWITCHES
| Component | Component Location |
|---|---|
| Back-Up Lamp Switch | On left side of transmission. |
| Brake Fluid Level Switch | In brake fluid reservoir cap. |
| Brake Lamp Switch | On bracket, above brake pedal. |
| Clutch Switch | On clutch pedal support bracket. |
| Double Temperature Switch | On right front of engine compartment. |
| Engine Coolant Level Switch | On right front side of engine compartment. |
| Engine Hood Switch | On right front side of engine compartment. |
| Inertia Switch | In lower right A-pillar. |
| Kick-Down Switch | Above accelerator pedal. |
| Oil Pressure Switch | On right front of engine below intake manifold. |
| Park Brake Switch | At base of parking brake lever. |
| Pressure Switch | On top of receiver-drier, behind right headlamp. |
| Temperature Switch | On front right side of engine compartment, near headlamp assembly. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.